Stainless steel hose fittings are a type of component that can be used with typically a more flexible ‘hose’ application, rather than hard pipe and tube.

Hose fittings are used often as connectors or adaptors. Common uses for hose fittings are within Hydraulic or Pneumatic industries.

Stainless steel hose adaptors, connectors and unions are available from Waverley Brownall, high quality fittings that can be used for a variety of functions.

Hose components up to 2″ made from stainless steel 316.

Common thread types: BSP, BPST, NPTF and BSPP.

• Male union hose fitting (3000lb class) in a range of sizes from 1/8″ to 2″.
• Bulkhead union with a hexagon back nut.
• Male and female hose adaptors (BSPT, NPTF, BSPP) in a range of sizes including 1/8″, 1/4″, 3/8″ up to 2″.

A) Female Hose Union Assembly
B) Female Hose Union 60 Degree Cone

Measurements and sizing for our hose fittings will use either the Hose ID (inside diameter) or tube OD (outside diameter). For example, our tube nipple cone is available in sizes for tube with an OD of 1/8″, 1/4″, 3/8″ etc.

Thread sizes are also used. Full information on this can be found within our precision pipe fittings catalogue on page 14, featuring just after our plugs, brushes and seals section.

A) Female Hose Union Assembly (Finger Tight)
B) Hose To Hose Connector

Hose clips in stainless steel can be supplied with your hose fittings, it is important to note that our hose clips are manufactured from grade 304 rather than 316.

A) OD Tube To Hose Coupling (Pictured: BSP Parallel male stud coupling)
B) Male Tube Union Assembly (Pictured: Nipple cone and union nut)

Finger Tight Hose Adaptor – Supplied with nitrile or PTFE O-ring seal for use with BSP union nut on previous page.

Related posts: